Volvo XC90: Activating or deactivating Connected Safety - DRIVER SUPPORTVolvo XC90: Activating or deactivating Connected Safety

For Connected Safety to be able to share information about road conditions with other drivers, the function must be activated. If you do not wish to share information, the function can be deactivated.

Volvo XC90. Activating or deactivating Connected Safety Activate or deactivate the function using this button in the center display's Function view.

  • Illuminated button indicator light – the function is activated.
  • Extinguished button indicator light – the function is deactivated.

At activation, the driver must accept the special terms and conditions shown in the display before an Internet connection1 can be established. The driver must, for example, accept that data is sent from the vehicle using the driver's cellular phone.

Even when your vehicle is not connected to the Internet, you will still be notified if the system in your own vehicle detects slippery road conditions. For Connected Safety to function at full capacity, your vehicle needs to be connected to the Internet.

1 There may be a charge for transmitting data over the Internet, depending on your service plan.

Connected Safety
(Not available in all markets.) Connected Safety communicates information between your vehicle and other vehicles via the Internet1. The function is designed to notify the driver of any hazardous road ...

Connected Safety limitations
Information on vehicles with activated hazard warning flashers or which have detected slippery road conditions is not always communicated between all vehicles in the affected area. This may be the case ...

See also:

Fuel Sender. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). Installation ...

Heated Oxygen Sensor (HO2S). Specifications
Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.5 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) Output Voltage(V) RICH Approx. 0.9 LEAN Approx. 0.04 ...

Manifold Absolute Pressure Sensor (MAPS). Schematic Diagrams
Circuit Diagram ...