Volvo XC90: Activating Park Assist Camera - DRIVER SUPPORTVolvo XC90: Activating Park Assist Camera

The Park Assist Camera (PAC1) is automatically activated when reverse gear is engaged or can be started manually using one of the center display's function buttons.

Camera view when backing up

When reverse gear is engaged, the screen shows the rear view2.

Camera view when manually activating the camera

Volvo XC90. Activating Park Assist Camera Activate the Park Assist Camera using this button in the center display's Function view.

The screen will first show the most recently used camera view. However, each time the engine is started, the previous side view will be replaced by the 360° view and a previously displayed zoomed-in rear view will be replaced by the regular rear view.

  • GREEN button indicator light – the function is activated.
  • GRAY button indicator light – the function is deactivated.

Automatically deactivating the camera

Front view switches off when the vehicle's speed reaches 25 km/h (16 mph) to help avoid distracting the driver. It will be automatically reactivated if the vehicle's speed falls below 22 km/h (14 mph) within 1 minute as long as the vehicle's speed has not exceeded 50 km/h (31 mph).

Other camera views switch off at 15 km/h (9 mph) and are not reactivated.

1 Park Assist Camera

2 In Canada, it is also possible to choose the 360° view. For the US, rear view is standard and cannot be changed.

Park Assist sensor field
If the vehicle is equipped with Park Assist (PAS1), distances will be shown in the Park Assist Camera's (PAC2) 360° view with colored fields for each sensor that has detected an obstacle. Front and rear ...

Park Assist Camera symbols and messages
Symbols and messages for the Park Assist Camera (PAC1) may be displayed in the instrument panel and/or the center display. Several examples are provided below. A An authorized Volvo workshop is recommended. ...

See also:

Rear Door Inside Handle. Repair procedures
Replacement 1. Remove the rear door trim. 2. After loosening the mounting screws, then remove the rear door inside handle (A). 3. Install in the reverse order of removal. • Make sure the door locks/unlocks ...

AUX(Auxiliary) Jack. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the console front complete assembly (A). 3. Remove the multimedia jack (B) after disconnecting the connector (A) from the console front ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at ...