Volvo XC90: Adjusting the rearview mirror dimming function - LIGHTINGVolvo XC90: Adjusting the rearview mirror dimming function

Bright light entering the vehicle from behind, e.g. from the headlights of following vehicles, could reflect in the rearview mirror and door mirrors and cause a glare. Use the dimming function when light from behind is distracting.

Auto-dim

If bright light enters the vehicle from behind, the door mirrors will automatically dim when it is dark outside or when lighting conditions are low, for example when driving in tunnels. Auto-dim is always active when the engine is running, except when reverse gear is engaged.

NOTE

Adjustments to the sensitivity level will not be noticeable immediately but will instead take effect after a short period of time.

The sensitivity level for dimming will affect both the rearview mirror and door mirrors.

To change the dimming sensitivity level:

  1. Tap Settings in the Top view in the center display.
  2. Tap My Car Volvo XC90. Adjusting the rearview mirror dimming function Mirrors and Convenience.
  3. Under Rearview Mirror Auto Dimming, select Normal, Dark or Light.

The rearview mirror has two sensors - one pointing forward and one pointing rearward - which work together to identify and eliminate glare. The forward-pointing sensor monitors ambient light, while the rearward-pointing sensor monitors light from the headlights of following vehicles.

For the door mirrors to be equipped with autodim, the rearview mirror must also be equipped with auto-dim.

NOTE

If the sensors are obstructed by e.g. a parking permit, transponder, sunshade or objects on the seats or in the cargo compartment in a way that prevents light from reaching the sensors, the auto-dim function in the door and rearview mirrors will be reduced.

Rearview/door mirrors
The rearview mirror and door mirrors can be used to improve the driver's visibility behind the vehicle. Rearview mirror The rearview mirror is equipped with Home- Link*, auto-dim* and compass*. The rearview ...

Adjusting the door mirrors
To improve visibility to the rear, the door mirrors need to be adjusted to the driver's height and seating position. There are several automatic settings that can also be connected to the memory function ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1,1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

Camshaft Position Sensor (CMPS). Troubleshooting
Wave Form ...

Rear Combination Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp (B). ...