Volvo XC90: Alarm - KEY, LOCKS AND ALARMVolvo XC90: Alarm

The alarm emits sound and light signals if anyone without a valid remote key attempts to break into the vehicle or interferes with the start battery or alarm siren.

Alarm indicator

Volvo XC90. Alarm

A red indicator light on the dashboard shows the status of the alarm:

  • Indicator off - the alarm is disarmed.
  • Indicator flashes once every two seconds - the alarm is armed.
  • The indicator flashes quickly after the alarm has been disabled for up to 30 seconds or until the ignition is put in I mode – the alarm has been triggered.

When armed, the alarm will be triggered if:

  • the hood, tailgate or any door is opened.
  • a battery cable is disconnected.
  • the alarm siren is disconnected.

Alarm signals

The following occurs if the alarm is triggered:

  • A siren will sound for 30 seconds or until the alarm is turned off.
  • The hazard warning flashers will flash for 5 minutes or until the alarm is turned off.

If the reason the alarm was triggered is not rectified, the alarm cycle will repeat up to 10 times1.

Symbols and messages

Volvo XC90. Alarm

NOTE

Do not attempt to repair or alter any of the components in the alarm system yourself. Any such attempt could affect the terms and conditions of your insurance policy.

1 Certain markets only.

Activating and deactivating private locking
Private locking is activated using the function button in the center display and a PIN code. NOTE For the valet lock function to be activated the car must be in at least ignition mode I. Two codes are ...

Arming and disarming the alarm
The alarm is armed when the vehicle is locked and disarmed when the vehicle is unlocked. The alarm can also be disarmed without a functioning key. Arming and disarming the alarm The alarm is armed when ...

See also:

Flow Diagram
Power Flow Chart P,N UD/B LR/B 26/B 35R/C OD/C OWC ● ▣ Direction of Rotation ▶Lower & Reverse Brake (LR/B) Activation → Overdrive (O/D) Hub Lock → Mid & Rear P/C Lock ...

Inhibitor Switch. Repair procedures
Inspection • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Power Circuit Inspection 1. Disconnect the Inhibitor swtich connector. ...

Changing the coolant
Have coolant changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. CAUTION Put a thick cloth or fabric around the radiator cap before refilling ...