Volvo XC90: Antenna locations for the start and lock system - KEY, LOCKS AND ALARMVolvo XC90: Antenna locations for the start and lock system

The antennas for the keyless start system and keyless locking system* are integrated in the vehicle.

Volvo XC90. Antenna locations for the start and lock system

Location of the antennas:

Volvo XC90. Antenna locations for the start and lock system Under the cup holder in the front section of the tunnel console

Volvo XC90. Antenna locations for the start and lock system In the upper front section of the left-side rear door1

Volvo XC90. Antenna locations for the start and lock system In the upper front section of the right-side rear door1

Volvo XC90. Antenna locations for the start and lock system In the center of the rear seat backrest1

WARNING

Individuals with an implanted pacemaker should not allow the pacemaker to come closer than 22 cm (9 in.) to the Keyless system antennas. The aim of this is to prevent disturbances between the pacemaker and the Keyless system.

1 Only in vehicles equipped with keyless locking and unlocking*.

* Option/accessory.

Keyless tailgate unlock
(Option/accessory.) With keyless locking and unlocking, the tailgate can be unlocked by lightly touching the rubberized button on the tailgate handle. NOTE One of the vehicle's remote keys must be within ...

Locking and unlocking from inside the vehicle
The doors and tailgate can be locked and unlocked from inside the vehicle using the central lock buttons in the front doors. Central locking Button with indicator light for locking and unlocking in front ...

See also:

Closing the sunroof
To close the sunroof glass and sunshade Push the sunroof control lever forward or pull the sunroof control lever down. The sunroof glass and sunshade will close automatically. To stop the sunroof movement ...

Description and Operation
Description Body Control Module Controls The Followings - Wiper & Washer Control - Defroster Control - Driving Control - Tailgate Control - Window Control - Interior Control - Exterior Control - Panic ...

License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...