Hyundai Santa Fe: Auto Head Lamp Leveling 
Unit. Repair procedures - Auto Head Lamp Leveling Device - Body Electrical SystemHyundai Santa Fe: Auto Head Lamp Leveling Unit. Repair procedures

Inspection

1.
Ignition "ON".
2.
Turn on the head lamp switch.
3.
Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned.
4.
If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 5.
5.
Substitute with a known-good head lamp assembly and check for proper operation.

Removal

1.
Remove the head lamp leveling unit connector (A).
2.
Loosen the mounting bolts (2EA) of automatic head lamp leveling unit (B).

Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lbf.ft)

3.
Remove the head lamp leveling unit assembly.

Installation

1.
Install the head lamp leveling unit.
2.
Reconnect the head lamp leveling unit connector.

    Auto Head Lamp Leveling Unit. Description and Operation
    Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's v ...

    See also:

    General Safety Information and Caution
    Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, ...

    Relay Box (Engine Compartment). Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay box. Powe ...

    Battery Sensor. Repair procedures
    Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remov ...