Volvo XC90: Changing waveband and radio station - AUDIO, MEDIA AND INTERNETVolvo XC90: Changing waveband and radio station

Instructions for changing wavebands, waveband lists and radio stations in the selected list are provided here.

Changing wavebands

Swipe from App view on the center display and select the desired waveband (e.g. FM) or open the App menu in the instrument panel with the right-side steering wheel keypad and make your selection there.

Changing a list in a waveband

Volvo XC90. Changing waveband and radio station

  1. Tap Library.
  2. Select playback from Stations, Favorites or Genres.
  3. Tap the desired station in the list.

Favorites – only plays selected favorite channels.

Genres - only plays channels broadcasting the selected genre or program type, e.g. pop, classical, etc.

Changing radio stations in a selected list

  • Press Volvo XC90. Changing waveband and radio station or Volvo XC90. Changing waveband and radio station under the center display or on the right-side steering wheel keypad.
  • Move step-by-step through the selected list.

It is also possible to change radio station in the selected list via the center display.

Starting the radio
The radio is started from the center display's App view. Open the desired waveband (e.g. FM) from App view. Select a radio station. ...

Searching for a radio station
The radio automatically compiles a list of the radio stations that are sending out the strongest signals in the vehicle's current location. Searching is performed in different ways depending on the waveband ...

See also:

Delta Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs. • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to ...

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...