Volvo XC90: Driving with the Start/Stop function - STARTING AND DRIVINGVolvo XC90: Driving with the Start/Stop function

Start/stop is a function that temporarily turns off the engine when the vehicle is stationary and then automatically starts it when needed. The Start/Stop function is available when the ignition is started and can be activated if certain conditions are met.

The instrument panel indicates when the function is

  • Available
  • active
  • not available.

All of the vehicle's ordinary systems, such as lighting, radio, etc. function normally when the engine has been auto-stopped. Certain functions may be temporarily reduced however such as the climate system's blower speed or extremely high audio system volume.

Auto-stop

To auto-stop the engine:

  • Stop the vehicle by applying the brakes and keep the brake pedal depressed. The engine will auto-stop.

In Comfort or Eco drive mode, the engine may auto-stop before the vehicle has com- pletely stopped.

With Adaptive Cruise Control or Pilot Assist activated, the engine will auto-stop about three seconds after the vehicle has stopped.

Auto-start

The following conditions must be met for the engine to auto-start.

  • Release the brake pedal. The engine will auto-start and the vehicle can be driven. On an uphill gradient, Hill Start Assist (HSA1 ) will activate to help prevent the vehicle from rolling backward.
  • When the Auto-hold function is activated, auto-start will be delayed until the accelerator is pressed.
  • When Adaptive Cruise Control or Pilot Assist are activated, the engine will autostart when the accelerator pedal is depressed or the Volvo XC90. Driving with the Start/Stop function button on the leftside steering wheel keypad is pressed.
  • Maintain pressure on the brake pedal and press the accelerator pedal. The engine will auto-start.
  • On a downhill gradient: Release the brake pedal slightly so that the vehicle begins to roll. The engine will auto-start after a slight increase in speed.

Symbols in the instrument panel

Volvo XC90. Driving with the Start/Stop function White – Displayed in the tachometer when the function is available.

Volvo XC90. Driving with the Start/Stop function Green – Shown in the tachometer when the function is active and the engine is auto-stopped.

Volvo XC90. Driving with the Start/Stop function Gray – When the symbol is grayedout with a line through it, the function is not available.

If no symbol is shown, the function is switched off.

Volvo XC90. Driving with the Start/Stop function

The function is active and the engine has auto-stopped.

On vehicles with the 8-inch instrument panel, the symbol will be shown at the bottom of the speedometer.

1 Hill Start Assist

Start/Stop function
Start/Stop is a function that temporarily switches off the engine when the vehicle has stopped, e.g. at a traffic light or in heavy traffic, and then starts it again automatically when needed. The Start/Stop ...

Deactivating the Start/Stop function
In certain situations, it may be advisable to turn the Start/Stop function off. To turn off Start/Stop, tap the Start/Stop function button in the center display's Function view. The indicator light in ...

See also:

Jump starting procedure
✽ NOTICE If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal ...

Sunvisor. Components and Components Location
Component Location 1. Sunvisor 2. Retainer ...

Cowl Cross Bar Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...