Hyundai Santa Fe: Emergency tailgate safety release - Tailgate - Features of your vehicle - Hyundai Santa Fe DM 2013-2018 Owner's ManualHyundai Santa Fe: Emergency tailgate safety release

Your vehicle is equipped with the emergency tailgate safety release lever located

Your vehicle is equipped with the emergency tailgate safety release lever located on the bottom of the tailgate. When someone is inadvertently locked in the luggage compartment, the tailgate can be opened by doing as follows:

1. Remove the cover.
2. Push the release lever to the right.
3. Push up the tailgate.

WARNING

  • For emergencies, be fully aware of the location of the emergency tailgate safety release lever in this vehicle and how to open the tailgate if you are accidentally locked in the luggage compartment.
  • No one should be allowed to occupy the luggage compartment of the vehicle at any time. The luggage compartment is a very dangerous location in the event of a crash.
  • Use the release lever for emergencies only. Use extreme caution, especially while the vehicle is in motion.
    Closing the tailgate
    To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING - Exhaust fumes If you drive with the tailgate open, you will draw danger ...

    Windows
    (1) Drivers door power window switch (2) Front passengers door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and clo ...

    See also:

    Anti-lock Brake System (ABS) Warning Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is ...

    Driver's and passenger's front air bag
    Your vehicle is equipped with a Supplemental Restraint (Air Bag) System and the lap/shoulder belts at both the driver and passenger seating positions. The indications of the system's presence ...

    Timing Chain. Repair procedures
    Removal 1. Remove the cylinder head cover. 2. Turn the crankshaft pulley and align its groove with the timing mark of the timing ...