Hyundai Santa Fe (DM): Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash-after 20 seconds.
2. Release both buttons. Do not hold for longer than 30 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When the indicator ...
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause ...
See also:
Opening the tailgate
The tailgate is locked or unlocked when all doors are locked or unlocked with the key, transmitter, smart key or central door lock switch. If unlocked, the tailgate can be opened by pressing the handle ...
Roof Antenna. Components and Components
Location
Components ...
Fuel Filler Door Open Switch. Repair
procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...
