Hyundai Santa Fe: Fan speed control - Heating and air conditioning - Manual climate control system - Features of your vehicleHyundai Santa Fe: Fan speed control

The ignition switch must be in the ON position for fan operation.

The ignition switch must be in the ON position for fan operation.

The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system. To change the fan speed, turn the knob to the right for higher speed or left for lower speed.

Setting the fan speed control knob to the “0” position turns off the fan.

Air intake control
This is used to select outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position The indicator light on the ...

To turn off the blowers
To turn off the blowers, turn the fan speed control knob to the “0” position. ...

See also:

Curtain air bag
❈ The actual air bags in the vehicle may differ from the illustration. Curtain air bags are located along both sides of the roof rails above the front and rear doors. They are designed to help ...

Engine oil
For the recommended service intervals and warranties to be applied, an approved engine oil must be used. Location of warning decal for the engine compartment. The layout of the engine compartment may vary ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake performance ...