Hyundai Santa Fe: Front Seat Assembly. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe: Front Seat Assembly. Repair procedures

Replacement

1.
Remove the front seat track mounting cover.
2.
After loosening the mounting bolts, remove the front seat assembly (A).
Tightening torque :
34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)

3.
Disconnect the seat buckle connector (A), seat warmer & power seat connector (B), SAB connector(C), PODS connector (D).
[Driver's]

[Passenger's]
4.
Install in the reverse order of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.

Front Seat Assembly. Components and Components Location
Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover. Components and Components Location
Component Location 1. Front seat shield outer cover ...

See also:

Curtain Airbag (CAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. 3. Disconnect the curtain airbag harness connector (A). 4. After loosening ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at ...

Heated Oxygen Sensor (HO2S). Specifications
Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.5 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) Output Voltage(V) RICH Approx. 0.9 LEAN Approx. 0.04 ...