Hyundai Santa Fe: Fuel Filter. Repair procedures
Removal
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
| 2. |
Disconnect the fuel sender connector (A).
|
| 3. |
Release the fixing hooks, and then remove the fuel sender (A).
|
| 4. |
Release the fixing hooks (A), and then fuel filter & motor assembly
from reservoir cup.
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Pump. Repair procedures
Inspection [Fuel pump motor] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Check motor operation by fuel pump connector (A) connecting power (No.4) ...
Fuel Pump Motor. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...
See also:
Forward and rearward
To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. ...
Lumbar support (for driver’s seat)
The lumbar support can be adjusted by pressing the switch. 1. Press the front portion (1) of the switch to increase support, or the rear portion (2) of the switch, to decrease support. 2. Release the ...
BJ Boot. Repair procedures
Removal 1. Remove the front driveshaft. 2. Remove the TJ joint assembly. 3. Remove the Dynamic damper. 4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A). 5. Remove the BJ boot. ...
