Hyundai Santa Fe: Fuel Pressure Regulator. Repair procedures
Removal
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
| 2. |
Release the fixing hooks, and then remove the regulator cup (A).
|
| 3. |
Remove the fuel pressure regulator (A).
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Sender. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). Installation ...
Fuel Line. Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) ...
See also:
Rail Pressure Sensor (RPS). Schematic Diagrams
Circuit Diagram ...
Vehicle stability management (VSM)
This system provides further enhancements to vehicle stability and steering responses when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient of friction between right ...
Air bag collision sensors
(1) SRS control module / Rollover sensor (if equipped) (2) Front impact sensor (3) Side impact sensor (4) Side impact sensor WARNING - Air bag sensors Do not hit or allow any objects to impact the locations ...
