Hyundai Santa Fe: Hazard warning flasher
Type A
Type B
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch.
This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through ...
Lighting
...
See also:
Smart key precautions
The smart key will not work if any of the following occur: - The smart key is close to a radio transmitter such as a radio station or an airport which can interfere with normal operation of the smart ...
Instrument Cluster. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). 3. Remove the cluster (A) from the housing after removing 2 screws. 4. Disconnect the cluster connecter ...
Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted when the ...
