Volvo XC90: Installing and removing the cargo compartment cover - LOADING, STORAGE AND PASSENGER COMPARTMENTVolvo XC90: Installing and removing the cargo compartment cover

The cover can be rolled out to conceal objects in the cargo compartment.

Installing the cargo compartment cover

Volvo XC90. Installing and removing the cargo compartment cover

Volvo XC90. Installing and removing the cargo compartment cover Press the end piece on one side of the cover into the retaining bracket in the side panel of the cargo compartment.

Volvo XC90. Installing and removing the cargo compartment cover Then put the other end piece in the recess in the side panel on the opposite side.

Volvo XC90. Installing and removing the cargo compartment cover Push the end piece down on both sides, one at a time.

  • When a click is heard and the red marks on each end piece are no longer visible, the cover is in place. Check that it is secure.

Removing the cargo compartment cover

In retracted position:

  1. Press the button on one of the cover's ends and lift out that end.

    For 7-seat models - remove the third row seat belt latches from the hooks above the side panels.

  2. Carefully lift the cover up and out.
    • The other end will release automatically and the cover can then be lifted out of the cargo compartment.

* Option/accessory.

Load anchoring eyelets
The load anchoring eyelets in the cargo compartment can be used to secure objects with straps, a net, etc. WARNING Hard, sharp and/or heavy objects in or protruding from the vehicle can cause injury in ...

Operating the cargo compartment cover
The cover can be used in two positions: fully open to completely cover the cargo compartment or partially retracted to make it easier to reach further into the cargo compartment. Fully open 7-seat models ...

See also:

Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket (1) and ...

Shift Cable. Repair procedures
Removal 1. Remove the floor console. 2. Remove the air duct. 3. Disconnect the shift cable (A). 4. Remove the retainer (A) and nut (B). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft) ...

Audio Remote Control. Repair procedures
Inspection 1. Check for resistance between terminals in each switch position. [Audio] Switch Connector terminal Resistance (В± 5%) SEEK up 2-7 430 Ω SEEK down 2-7 1.11 kΩ Mode 2-7 2.11 kΩ ...