Hyundai Santa Fe (DM): Instrument Cluster. Description and Operation
Description
Abbreviation |
Explanation |
C_CAN |
Chassis Controller Area Network |
B_CAN |
Body Controller Area Network |
MM_CAN |
Multi media Controller Area Network |
SMK |
Smart Key ECU |
DDM |
Driver Door Module |
ADM |
Assist Door Module |
PSM |
Power Seat Module |
SJB |
Smart Junction Box |
ESC |
Electronic Stabilty Control |
SPAS |
Smart Parking Assist System |
SWRC |
Steering Wheel Remote Controller |
PCU |
Power-train Control Unit |
ECU |
Engine Control Unit |
TCU |
Transmission Control Unit |
EPB |
Electronic Parking Brake |
ABS |
Anti-lock Brake System |
BCM |
Body Control Module |
SCC |
Smart Cruise Control |
DATC |
Dual Automatic Temp Control |
MDPS |
Motor Driven Power Steering |
SAS |
Steering Angle Sensor |
TPMS |
Tire Pressure Monitoring System |
ACU |
Airbag Control Unit |
CLU |
Cluster |
HU |
Head Unit (Audio, AVN, MTS) |
Instrument Cluster. Schematic Diagrams
Circuit Diagram ...Instrument Cluster. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). 3. Remove the cluster (A) from the housing after removing 2 screws. 4. Disconnect the cluster connecter ...See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
General Information. Repair procedures
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the engine to warm up ...
Repair procedures
Valve Clearance Inspection And Adjustment Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C (68°F)) and cylinder head is installed on the cylinder block. ...