Hyundai Santa Fe: License Lamps. Repair procedures - Lighting System - Body Electrical SystemHyundai Santa Fe: License Lamps. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens (A) from the panel after loosening a screw.
3.
Replace the bulb (B) after removing the license lamp (A).

Installation

1.
Install the bulb.
2.
Install the license lamp lens.

Front Fog Lamps. Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction ...

High Mounted Stop Lamp. Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. 3. Remove the high mounted stop lamp assembly (A) after loosening screws (4EA). Installation ...

See also:

Front Hub / Knuckle / Tone Wheel. Components and Components Location
Components 1. Knuckle 2. Dust cover 3. Hub assembly 4. Brake disc ...

Camshaft Position Sensor (CMPS). Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or ...

Parking Brake Lever Assembly. Repair procedures
Removal The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. 1. Remove the floor console assembly. 2. Disconnect the connector (A) of parking ...