Hyundai Santa Fe: Lumbar support (for driver’s seat)
The lumbar support can be adjusted by pressing the switch.
1. Press the front portion (1) of the switch to increase support, or the rear
portion (2) of the switch, to decrease support.
2. Release the switch once it reaches the desired position.
3. Press the upper portion (3) of the switch to move the support position up, or
press the lower portion (4) of the switch, to move the support position down.
4. Release the switch once it reaches the desired position.
Seatback angle
1. Push the control switch forward or backward to move the seatback to the desired angle. 2. Release the switch once the seat reaches the desired position. Seat height (for driver’s seat) 1. Pull the ...
Headrest
The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort. The headrest not only provides comfort for the driver and front passenger, but ...
See also:
Immobilizer Indicator Light (With Smart Key)
This indicator light illuminates for up to 30 seconds: • When the vehicle detects the smart key in the vehicle properly while the Engine Start/Stop Button is ACC or ON. - At this time, you can start ...
SS-A Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Trip A/B
Tripmeter (1) The tripmeter is the total driving distance since the last tripmeter reset. - Distance range: 0.0 ~ 9999.9 mi. or km To reset the tripmeter, press the SELECT/RESET button on the steering ...
