Hyundai Santa Fe: Oil Level Gauge & Pipe. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Santa Fe: Oil Level Gauge & Pipe. Repair procedures

Removal and Installation

1.
Remove the oil gauge(A).
2.
Remove the intake manofold.
3.
Remove the oil level pipe(A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install in the reverse order of removal.

Oil Pressure Switch. Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal and the body ...

Intake And Exhaust System
...

See also:

Rear combination lamp bulb replacement
(1) Rear stop and tail lamp (2) Rear tail lamp (3) Rear turn signal lamp (4) Back-up lamp (5) Rear side marker ...

Owner’s responsibility
✽ NOTICE Maintenance Service and Record Retention are the owner's responsibility. You should retain documents that show proper maintenance has been performed on your vehicle in accordance with ...

License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...