Volvo XC90: Ordering additional remote keys - KEY, LOCKS AND ALARMVolvo XC90: Ordering additional remote keys

Two remote keys are provided with the vehicle. One Key Tag is also included if the vehicle is equipped with keyless locking/unlocking *. Additional keys can be ordered.

A total of 12 keys can be programmed and used for the same vehicle. An additional driver profile will be added for each new remote key. This also applies to the key tag.

Loss of a remote key

If you lose your remote key, you can order a replacement from a workshop - an authorized Volvo workshop is recommended. Bring the other remaining remote keys to the workshop. As an anti-theft measure, the code of the lost remote key must be erased from the system.

The current number of keys registered for the vehicle can be checked via driver profiles in the center display's Top view. Select Settings Volvo XC90. Ordering additional remote keys System Volvo XC90. Ordering additional remote keys Driver Profiles.

NOTE

Volvo recommends that you order a new or duplicate remote key from an authorized Volvo workshop.

You can also obtain additional or duplicate remote keys from certain independent repair facilities and locksmiths that are qualified to make remote keys. Each key must be programmed to work with your vehicle.

A list of independent repair facilities and/or locksmiths known to Volvo that can cut and code replacement keys can be found:

  • at volvocars.com
  • by calling Volvo Customer Care 1-800-458-1552.

* Option/accessory.

Replacing the remote key's battery
The battery in the remote key must be replaced when it is discharged. NOTE All batteries have a limited service life and must eventually be replaced (does not apply for Key Tag). The battery's service ...

Care Key – restricted remote key
A Care Key enables the vehicle owner to set a maximum speed limit for the vehicle. This limit is intended to promote safe use of the vehicle, e.g. when it is loaned out. A maximum vehicle speed can be ...

See also:

Immobilizer Control Unit. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Remove the knee airbag module. 4. Disconnect the connector of the immobilizer unit and then remove ...

Fluid. Repair procedures
Service Adjustment Procedure Oil level Check A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after replairs are completed. ...

Knee Airbag (KAB) Module. Components and Components Location
Components ...