Hyundai Santa Fe: Programming HomeLink - Mirrors - Features of your vehicle - Hyundai Santa Fe DM 2013-2018 Owner's ManualHyundai Santa Fe: Programming HomeLink

✽ NOTICE

  • When programming a garage door opener, it is advised to park the vehicle outside of the garage.
  • It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency signal.
  • Some vehicles may require the ignition switch to be turned to the second (or "accessories") position for programming and/or operation of HomeLink.
  • In the event that there are still programming difficulties or questions after following the programming steps listed below, contact HomeLink at: www.homelink.com or 1-800-355-3515.
Compass function
The Compass can be turned ON and OFF and will remember the last state when the ignition is cycled. To turn the display feature ON/OFF: 1. Press and release the button to turn the display feature OF ...

Standard programming
To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons, HomeLink Channel 1 and Channel 3 Buttons, until the indicator light begins ...

See also:

Air bag - supplemental restraint system
(1) Drivers front air bag (2) Passengers front air bag (3) Side impact air bag (4) Curtain air bag (5) Drivers knee air bag WARNING Even in vehicles with air bags, you and your passengers m ...

TJ Joint. Repair procedures
Removal Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may be determined by the following: Reference the device owner's manual for verification. The handheld ...