Hyundai Santa Fe: Rear Stabilizer Bar. Repair procedures
Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
In the case of 4WD vehicle, remove the rear differential assembly.
|
| 3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
| 4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
| 5. |
Installation is the reverse of removal.
|
Inspection
| 1. |
Check the rear stabilizer bar for deformation.
|
| 2. |
Check the rear stabilizer link ball joint for damage.
|
Rear Assist Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
Rear Cross Member. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the front wheel & tire ...
See also:
Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer. HI : High wiper speed ...
ESC Control Module. Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Remove the brake fluid from the master cylinder reservoir with a syringe. • Be sure to completely remove foreign substances from around brake fluid reservoir ...
General Information
General The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the driver, ...





