Hyundai Santa Fe: Removing and storing the spare tire - If you have a flat tire - What to do in an emergency - Hyundai Santa Fe DM 2013-2018 Owner's ManualHyundai Santa Fe: Removing and storing the spare tire

Your spare tire is stored underneath your vehicle, directly below the cargo area.

Your spare tire is stored underneath your vehicle, directly below the cargo area.

To remove the spare tire:

1. Open the tailgate.
2. Find the plastic hex bolt cover and remove the cover with coin or flathead screwdriver.

3. Connect the socket and wheel lug nut wrench.

3. Connect the socket and wheel lug nut wrench.
4. Loosen the bolt enough to lower the spare tire.

Turn the wrench counterclockwise until the spare tire reaches the ground.

5. After the spare tire reaches the ground, continue to turn the wrench counterclockwise,

5. After the spare tire reaches the ground, continue to turn the wrench counterclockwise, and draw the spare tire outside. Never rotate the wrench excessively, otherwise the spare tire carrier may be damaged.
6. Remove the retainer (1) from the center of the spare tire

To store the spare tire:

To store the spare tire:

1. Lay the tire on the ground with the valve stem facing up.
2. Place the wheel under the vehicle and install the retainer (1) through the wheel center.
3. Turn the wrench clockwise until it clicks.

WARNING - Storing the spare tire

Ensure the spare tire retainer is properly aligned with the center of the spare tire to prevent the spare tire from rattling.

Otherwise, it may cause the spare tire to fall off the carrier and lead to an accident.

    Jack and tools
    The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to find these equipment. (1) Jack handle (2) Jack (3) Wheel lug nut wrench ...

    Changing tires
    1. Park on a level surface and apply the parking brake firmly. 2. Shift the shift lever into P (Park). 3. Activate the hazard warning flasher. 4. Remove the wheel lug nut wrench, jack, jack han ...

    See also:

    Lumbar support (for drivers seat)
    1. Press the front portion of the switch to increase support or the rear portion of the switch to decrease support. 2. Release the switch once it reaches the desired position. ...

    Engine Oil Pressure Warning Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When the engine oil pressure is ...

    Immobilizer Control Unit. Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. 3. ...