Hyundai Santa Fe: Repair procedures - Fuel Filler Door - Body (Interior and Exterior)Hyundai Santa Fe: Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
1.
Open the fuel filler door.
2.
Remove the fuel filler door mounting pin (A) by turning it counter clock-wise.
3.
After loosening the mounting screws, then remove the fuel filler door packing (A).
4.
Remove the fuel filler door housing (A).
•
Pull out from inside of the packing part (B) When removing the fuel filler door housing.

5.
Install in the reverse order of removal.
•
Make sure the fuel filler door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

Components and Components Location
Component Location 1. Fuel filler door ...

Front Door
...

See also:

Power Seat Motor. Repair procedures
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Slide motor B : Front height motor C : Rear height motor D : Lumbar support motor (Horizontal) E : Lumbar support motor (Vertical) ...

Standard programming
To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons, HomeLink® Channel 1 and Channel 3 Buttons, until the indicator light begins to ...

Manifold Absolute Pressure Sensor (MAPS). Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional ...