Volvo XC90: Replacing the low beam headlight bulbs - MAINTENANCE AND SERVICEVolvo XC90: Replacing the low beam headlight bulbs

The low beam bulbs in the halogen headlights can be changed without the help of a workshop.

Before the bulbs can be replaced, the plastic covering over the headlight must be removed.

CAUTION

Never touch the bulb glass with your bare fingers. Grease and oils from your fingers vaporize in the heat and will leave a deposit on the reflector, which may damage it.

Volvo XC90. Replacing the low beam headlight bulbs

Left headlight.

  1. Remove the round low beam rubber cover from the headlight housing.
  2. Remove the connector from the bulb.
  3. Remove the bulb by pressing it slightly upward and then pulling it out.
  4. Insert the new bulb in the socket. The bulb's guiding pin should point straight up.
  5. Press the connector into place.
  6. Put the round rubber cover back in place.
Location of exterior lights
The vehicle's exterior lighting consists of several different bulbs. LED1 bulbs must be replaced by a workshop. An authorized Volvo workshop is recommended. Front bulbs (vehicles with halogen headlights) ...

Replacing the high beam headlight bulbs
The high beam bulbs in the halogen headlights can be changed without the help of a workshop. Before the bulbs can be replaced, the plastic covering over the headlight must be removed. Before the lamp can ...

See also:

Filter inspection
If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate ...

Leveling control and suspension
(Option/accessory.) The vehicle's leveling control system adjusts the suspension and shock absorbers automatically to help optimize comfort and control while driving. Leveling can also be controlled manually ...

Inside lamp
1. Open the tailgate. 2. Remove the service cover using a flat-blade screwdriver. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with ...