Hyundai Santa Fe: Seat Belt Buckle Switch (BS). Description and Operation - SRSCM - RestraintHyundai Santa Fe: Seat Belt Buckle Switch (BS). Description and Operation

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS). Description and Operation

Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Side Impact Sensor (SIS). Repair procedures
Removal Pressure Side Impact Sensor (P-SIS) • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnecting the side impact sensor connector(s), ...

Seat Belt Buckle Switch (BS). Components and Components Location
Components ...

See also:

Emergency Fastening Device (EFD). Description and Operation
Description The Emergency Fastening Device (EFD) operates as well as the belt pretensioner at the same time, if it gets into its deploy condition after a collision. It is located near the anchor on the ...

Electronic Brake force Distribution (EBD) System Warning Light
These two warning lights illuminate at the same time while driving: • When the ABS and regular brake system may not work normally. In this case, have your vehicle inspected by an authorized HYUNDAI ...

Parking Brake Lever Assembly. Repair procedures
Removal The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. 1. Remove the floor console assembly. 2. Disconnect the connector (A) of parking ...