Volvo XC90: Setting maximum opening height for the power tailgate - KEY, LOCKS AND ALARMVolvo XC90: Setting maximum opening height for the power tailgate

(Option/accessory)

The tailgate can be set to stop opening at a certain height, for example if the tailgate needs to be opened in a garage with a low ceiling.

Setting maximum opening height

  1. Open the tailgate manually to the desired opening height.
  2. Press the Volvo XC90. Setting maximum opening height for the power tailgate button on the lower edge of the tailgate and hold it for about 3 seconds.
    • Two audio signals will sound to indicate that the position has been stored.

NOTE

It is not possible to program an opening position lower than half-open tailgate.

Resetting maximum opening position

  1. Open the tailgate manually to the fully open position.
  2. Press the Volvo XC90. Setting maximum opening height for the power tailgate button on the lower edge of the tailgate and hold it for about 3 seconds.
    • Two audio signals will sound to indicate that the stored position has been erased.

NOTE

If the system has been working continuously for a prolonged period of time, it will be switched off to avoid overload. It can be used again after approximately 2 minutes.

Closing and locking the tailgate using the buttons
(Option/accessory). The buttons on the underside of the tailgate can be used to close and lock the vehicle automatically. Location of button(s) on underside of tailgate CAUTION When operating the tailgate ...

Operating the tailgate with a foot movement
(Option/accessory) To make it easier to operate the tailgate when your hands are full, it can be opened and closed by moving your foot in a forward kicking motion under the rear bumper. The sensor is located ...

See also:

Cruise control
Cruise Control (CC1) can help the driver maintain an even speed to provide a more relaxing driving experience on highways and long, straight roads with even traffic flows. Function buttons and symbols ...

Components and Components Location
Component Location 1. Fuel filler door open switch 2. Fuel filler door release actuator ...

Oil Seal. Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools. • Apply lithium ...