Hyundai Santa Fe: Special Service Tools
Special Service Tools
|
Tool(Number and Name) |
Illustration |
Use |
|
09495-33000 Puller |
|
Removal of spider assembly from a drive shaft. |
|
09568-4A000 Ball joint puller |
|
Remove the ball joint |
|
09495-3K000 Band installer |
|
Installation of ear type boot band |
Specifications
Specification Items Inner side Outer side Front driveshaft Joint type LSJ 104 UBJ 104 Max. permissible angle 23.5° 46.5° Rear driveshaft Joint type TJ BJ Max. permissible angle 23.5° 46.5° Rear differential ...
Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace Defective front suspension and ...
See also:
Removal and installation
To remove the headrest : 1. Raise it as far as it can go then press the release button (1) while pulling the headrest up (2). To reinstall the headrest : 1. Put the headrest poles (3) into the holes while ...
Crankshaft Position Sensor (CKPS). Schematic Diagrams
Circuit Diagram ...
Wipers and washers
A :Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent wipe time adjustment C :Wash with brief ...
