Volvo XC90: Switching target vehicles with driver support - DRIVER SUPPORTVolvo XC90: Switching target vehicles with driver support

At certain speeds, vehicles with automatic transmissions and the driver support functions Adaptive Cruise Control* and Pilot Assist* can switch target vehicles.

Switching target vehicles

Volvo XC90. Switching target vehicles with driver support

If the target vehicle ahead turns suddenly, there may be stationary traffic ahead.

When driver support is actively following another vehicle at speeds under 30 km/h (20 mph) and switches targets from a moving vehicle to a stationary vehicle, driver support will brake for the stationary vehicle.

WARNING

When driver support follows another vehicle at speeds over approx. 30 km/h (20 mph) and changes target vehicle – from a moving vehicle to a stationary one – driver support will ignore the stationary vehicle and instead accelerate to the stored speed.

  • The driver must then intervene and apply the brakes.

Automatic standby mode when switching targets

Driver support disengages and goes into standby mode if:

  • your vehicle's speed goes under 5 km/h (3 mph) and driver support cannot determine if the target vehicle is stationary or if it is another object, e.g. a speed bump.
  • your vehicle's speed goes under 5 km/h (3 mph) and the vehicle ahead turns so that driver support no longer has a vehicle to follow.

* Option/accessory.

Collision risk warning from driver support
The driver support systems Adaptive Cruise Control* and Pilot Assist* can help alert the driver if the distance to the vehicle ahead suddenly decreases to an unsafe distance. Collision warning audible ...

Adjusting set speed for driver support
It is possible to adjust set speeds for the cruise control, Adaptive Cruise Control* and Pilot Assist* functions. : Increases the set speed : Reduces the set speed Set speed Change a set speed by pressing ...

See also:

Hood Lift. Repair procedures
Replacement • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, lift the socket clips (A) up slightly on ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications Direct control VFS[OD/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...

Water pump. Troubleshooting
Troubleshooting Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace ...