Hyundai Santa Fe: Tail Gate Back Panel. Repair procedures - Tail Gate - Body (Interior and Exterior)Hyundai Santa Fe: Tail Gate Back Panel. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the tail gate trim.
2.
Disconnect the license lamp connector and back view camera connector (A).
3.
Loosen the tail gate back panel mounting nuts (A).
[Side]

[Center]
4.
Using a screwdriver or remover, remove the tail gate back panel (A).
5.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Tail Gate Back Panel. Components and Components Location
Component Location 1. Tail gate back panel ...

Tail Gate Lift. Repair procedures
Replacement • Take care to not let the tailgate fall on you as the lifts are removed. Have a helper hold the tailgate open, or use a secure method to hold it open. 1. Using a screwdriver (A), lift up ...

See also:

Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram ...

Repair procedures
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. 2. Remove the rear door window glass mounting hole ...

Front Alignment. Repair procedures
Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels ...