Hyundai Santa Fe: Troubleshooting
Troubleshooting
|
Symptom |
Suspect Area |
Remedy (Refer to page) |
|
Water leaks from panorama sunroof |
Deteriorated roof lid weatherstrip |
Replace |
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
|
Wind noise around Panorama sunroof |
Loose or deformed deflector, gaps in body work |
Retighten adjust or replace |
|
Noise heard when opening/ closing Panorama sunroof |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Loose guide rails and lid |
Retighten |
|
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
|
Incorrect engagement of motor pinion with drive cable |
||
|
Decrease in motor`s clutch slipping force |
||
|
Increased sunroof sliding resistance or interference of sunroof with
drive cables, weatherstrip, etc. due tomal adjustment of sunroof |
||
|
Noise in motor (clutch slipping noise from motor when sunroof is fully
opened or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and |
|
Re-tighten motor |
||
|
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
|
Worn out or deformed drive cable |
Replace |
|
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
|
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
|
Defective door check assembly |
Correct or replace |
|
|
Door hinge requires grease |
Apply grease |
|
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
|
Incorrectly installed hood |
Adjust |
|
|
Incorrect hood bumper height |
Adjust |
|
|
Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
|
Defective flange |
Correct |
Special Service Tools
Special Service Tools Tool (Number and name) Illustration Use 09861-31100 Sealany cut-out tool Cutting windshield sealant (use with 09861-31200) 09861-31200 Sealant cutting blade Cutting windshield sealant ...
Body Dimensions
...
See also:
Parking Assist Sensor. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. 3. Disconnect the connector (B) from the parking assist sensor (A). 4. Pull out the sensor (A) by opening the sensor ...
Hood Insulator Pad. Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). • Be careful not to scratch the hood panel. 2. Install in the reverse order of removal. • Replace any damaged ...
Troubleshooting
Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. If necessary, ...
