Hyundai Santa Fe: Troubleshooting
Troubleshooting
|
Problem |
Possible cause |
Solution |
|
Not pairing |
Bluetooth device of Car is not discoverable mode |
Enter Bluetooth pairing (searching) mode |
|
User’s phone is Bluetooth off mode |
User’s phone set Bluetooth on |
|
|
Making an attempt pairing others bluetooth system |
Check Bluetooth device name and address (12 word) to
attempt paring Ex) 000B24FFF123 |
|
|
Pass key error |
Input the passkey displayed on the audio screen into
the phone. |
|
|
5 phones have already been registered. |
Delete paired phone list |
|
|
Bluetooth system cannot communicate with the phone. |
Refer to IOP sheet ※IOP : Inter-operability |
|
|
Not connection |
User’s phone or Bluetooth device of Car dose not register
Bluetooth device to connect |
Retry pairing |
|
Bluetooth system cannot communicate with the phone. |
Waiting 1minute then Retry connection or phone power
off/on. Refer to IOP sheet |
|
|
Not redial |
User phone system issue |
Push the 2 times Send button |
|
Not accept call |
User phone system issue |
Refer to IOP sheet |
|
Not dialing |
User’s phone playing other menu (internet, mp3, game,
etc..) |
Stop other menu then set normal mode |
|
Bluetooth system cannot communicate with the phone |
Refer to IOP sheet |
Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Seperate the handsfree mic (A) from the roof trim. 3. Remove the handsfree mic (B) after disconnecting the handsfree mic connector (A). 4. ...
Panorama Sunroof
...
See also:
Hood Weatherstrip. Repair procedures
Replacement 1. Remove the hood weatherstrip (A). • Be careful not to scratch the hood weatherstrip. 2. Install in the reverse order of removal. ...
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the CRUISE button was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when you move the lever up (to RES+). ...
Seat Heater (Air Ventilation). Repair
procedures
Inspection Front Seat 1. Check for continuity and measure the resistance between terminals. No. Description No. Description 1 Heater cushion + 4 Heater back + 2 NTC + 5 - 3 Ground 6 NTC - Standard value ...
