Hyundai Santa Fe: Troubleshooting
Troubleshooting
| Ignition System |
|
Symptom |
Suspect Area |
Remedy |
|
Engine will not start or is hard to start (Cranks OK) |
Ignition lock switch |
Inspect ignition lock switch, or replace as required |
|
Ignition coil |
Inspect ignition coil, or replace as required |
|
|
Spark plugs |
Inspect spark plugs, or replace as required |
|
|
Ignition wiring disconnected or broken |
Repair wiring, or replace as required |
|
|
Rough idle or stalls |
Ignition wiring |
Repair wiring, or replace as required |
|
Ignition coil |
Inspect ignition coil, or replace as required |
|
|
Engine hesitates/poor acceleration |
Spark plugs and spark plug cables |
Inspect spark plugs / cable, or replace as required |
|
Ignition wiring |
Repair wiring, or replace as required |
|
|
Poor mileage |
Spark plugs and spark plug cables |
Inspect spark plugs / cable, or replace as required |
| Charging System |
|
Symptom |
Suspect Area |
Remedy |
|
Charging warning indicator does not light with ignition switch "ON" and engine off. |
Fuse blown |
Check fuses |
|
Light burned out |
Replace light |
|
|
Wiring connection loose |
Tighten loose connection |
|
|
Electronic voltage regulator |
If light turns off, replace voltage regulator. |
|
|
Charging warning indicator does not go out with engine running. (Battery requires frequent recharging) |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Battery cable loose, corroded or worn |
Inspect cable connection, repair or replace cable |
|
|
Electronic voltage regulator or alternator |
If light turns off, replace voltage regulator or alternator |
|
|
Wiring |
Repair or replace wiring |
|
|
Overcharge |
Electronic voltage regulator |
If light turns off, replace voltage regulator. |
|
Voltage sensing wire |
Repair or replace wiring |
|
|
Discharge |
Drive belt loose or worn |
Adjust belt tension or replace belt |
|
Wiring connection loose or short circuit |
Inspect wiring connection, repair or replace wiring |
|
|
Electronic voltage regulator or alternator |
If light turns off, replace voltage regulator or alternator |
|
|
Poor grounding |
Inspect ground or repair |
|
|
Worn battery |
Replace battery |
| Starting System |
|
Symptom |
Suspect Area |
Remedy |
|
Engine will not crank |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Transaxle range switch (Vehicle with automatic transaxle only) |
Refer to AT group-automatic transaxle |
|
|
Fuse blown |
Replace fuse |
|
|
Starter motor faulty |
Replace |
|
|
Ignition switch faulty |
Replace |
|
|
Engine cranks slowly |
Battery charge low |
Charge or replace battery |
|
Battery cables loose, corroded or worn out |
Repair or replace cables |
|
|
Starter motor faulty |
Replace |
|
|
Starter keeps running |
Starter motor faulty |
Replace |
|
Ignition switch |
Replace |
|
|
Starter spins but engine will not crank |
Short in wiring |
Repair or replace wiring |
|
Pinion gear teeth broken or starter motor |
Replace |
|
|
Ring gear teeth broken |
Replace fly wheel or torque converter |
Specifications
Specification Ignition System Ignition Coil Item Specification Primary Coil Resistance (Ω) 0.62 ± 10% [20°C (68°F)] Secondary Coil Resistance (kΩ) 7.0 ± 15% [20°C (68°F)] ...
Special Service Tools
Special Service Tools Tool (Number and name) Illustration Use Alternator pulley remover wrench (09373-27000) Removal and installation of alternator pulley ...
See also:
Components and Components Location
Component Location 1. Automatic transaxle 2. Inhibitor switch 3. Transaxle Control Module (TCM) 4. Valve body cover 5. Solenoid valve connect 6. Oil temperature sensor 7. Valve body assembly 8. Line Pressure ...
Instrument Cluster. Components
and Components Location
Components Connector Pin Information No. Description No. Description 1 - 21 - 2 Illumination output 22 - 3 Rheostat down switch 23 4P output 4 Rheostat up switch 24 Immobilizer 5 AT N output 25 AT S output ...
Parking Brake & Brake Fluid Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds - It remains on if the parking brake is applied. ...
