Volvo XC90: Using HomeLink® - STARTING AND DRIVINGVolvo XC90: Using HomeLink®

(Option/accessory.) (Certain markets only.)

Once HomeLink® is programmed, it can be used instead of the separate remote controls. Press and hold the programming button. The garage door, gate, alarm system, etc. will be activated (this may take several seconds). If the button is held down for more than 20 seconds, reprogramming will begin. The indicator light will glow steadily or flash when the button has been pressed. The original remote controls may be used concurrently with HomeLink® if desired.

NOTE

When the ignition is switched off, HomeLink® will be active for at least 7 minutes.

NOTE

HomeLink® cannot be used if the vehicle is locked and the alarm is armed* from the outside.

WARNING

If you use HomeLink® to open a garage door or gate, be sure no one is near the gate or door while it is in motion.

Do not use HomeLink® with any garage door opener that lacks safety stop and reverse features as required by U.S. federal safety standards (this includes any garage door opener model manufactured before April 1, 1982). A garage door that cannot detect an object - signaling the door to stop and reverse - does not meet current U.S. federal safety standards. For more information, contact HomeLink at: homelink.com.

Programming HomeLink®
(Option/accessory.) (Certain markets only.) Follow these instructions to program HomeLink®, reset all programming, or program individual buttons. NOTE In some vehicles, the ignition must be on or in the ...

Type approval for HomeLink®
(Option/accessory.) (Certain markets only.) FCC (USA) and IC (Canada) This device complies with FCC rules part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions: (1) ...

See also:

Loading recommendations
There are a number of things that are important to consider when carrying loads in or on the vehicle. Load-carrying capacity is determined by the vehicle's curb weight. The total weight of all passengers ...

Front Seat Belt Pretensioner. Repair procedures
Replacement • When installing the belt, make sure not to damage the pretensioner. 1. Remove the center pillar upper trim. 2. After loosening the mounting bolt, then remove the front seat belt upper anchor ...

Starting and moving the vehicle when it is in safety mode
If safety mode has been set, it may be possible to reset the system in order to start and move the vehicle a short distance, for example, if it is blocking traffic. Starting the vehicle when it is in safety ...