Volvo XC90: Using the windshield and head-light washers - LIGHTINGVolvo XC90: Using the windshield and head-light washers

The windshield and headlight washers are designed to clean the windshield and headlights. Use the right-side steering wheel lever to start the windshield and headlight washers.

Starting the windshield and headlight washers

Volvo XC90. Using the windshield and head-light washers

Washing function, right-hand steering wheel lever.

  • Move the right-hand steering wheel lever toward the steering wheel to start the windshield and headlight washers.
    • After the lever is released, the wipers make several extra sweeps.

CAUTION

Avoid activating the washer system when it is frozen or the fluid reservoir is empty. Otherwise, there is a risk of damaging the pump.

Headlight washer*

To save washer fluid, the headlights are washed automatically according to a defined interval when the headlights are on.

Reduced washing

When there is about 1 liter (1 qt) of washer fluid left in the reservoir and the Washer fluid Level low, refill message is displayed in the instrument panel together with the Volvo XC90. Using the windshield and head-light washers symbol, the washer fluid supply to the headlights is cut off. This is to prioritize windshield cleaning and visibility through it. The headlights are only washed if high or low beam is on.

* Option/accessory.

Activating and deactivating the rain sensor's memory function
The rain sensor monitors the amount of water on the windshield and automatically starts the windshield wipers. When the memory function is activated, the rain sensor button does not need to be pressed ...

Using the rear window wiper/washer
The rear window washer/wiper is designed to clean the rear window. Use the right-side steering wheel lever to start and control the wiper/washer. Activating the rear window wiper/washer NOTE The rear window ...

See also:

Transaxle Control Module (TCM). Schematic Diagrams
1. TCM connector and terminal function 2. TCM Terminal Function Connector [A] Pin Description Pin Description 1 ㅡ 54 ㅡ 2 Line pressure control solenoid valve (LINE_VFS) 55 ㅡ 3 Torque ...

Turn Signal Lamp. Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside mirror assembly. Be careful not to damage the fixing clip 3. Remove ...

Drive Plate. Repair procedures
Removal and Installation 1. Remove the automatic transaxle . 2. Remove the drive plate (A) and the adapter plate (B). Tightening torque : 117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft) • Always ...