Hyundai Santa Fe: Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe: Variable Intake Solenoid (VIS) Valve. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.
Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector (A).
3.
Disconnect the vacuum hoses (B,C) from the valve.
4.
Remove the installation bolt (D), and then remove the valve from the surge tank.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.

Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram ...

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine ...

See also:

Inner panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Open the fuse panel cover. 3. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse panel. 4. Check ...

Lift And Support Points
Lift And Support Points When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When ...

Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected ...