Hyundai Santa Fe: Vehicle certification label - Specifications, Consumer information and Reporting safety defects - Hyundai Santa Fe DM 2013-2019 Owner's ManualHyundai Santa Fe: Vehicle certification label

The vehicle certification label attached on the drivers side center pillar gives

The vehicle certification label attached on the drivers side center pillar gives the vehicle identification number (VIN).

    Vehicle identification number (VIN)
    The vehicle identification number (VIN) is the number used in registering your vehicle and in all legal matters pertaining to its ownership, etc. The number is punched on the engine compartment ...

    Tire specification and pressure label
    The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures re ...

    See also:

    If you do decide to pull a trailer
    Here are some important points if you decide to pull a trailer: Consider using a sway control.You can ask a hitch dealer about sway control. Do not do any towing with your car during its first 1 ...

    Manifold Absolute Pressure Sensor (MAPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ...

    Downhill Brake Control (DBC) Indicator Light
    This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you acti ...