Hyundai Santa Fe: Inhibitor Switch. Description and Operation
Description
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
SS-B Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Inhibitor Switch. Specifications
Specifications ▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V) 12 Output type Pin to Pin ▷ Signal Code Table P P-R R R-N N N-D D S1 12V ...
See also:
Basic Service Symbols
Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning Do not reuse the part. Replace ...
Rear Transverse Trim. Components and Components Location
Component Location 1. Rear transverse trim ...
Components and Components Location
Component Location 1. Power outlet relay 2. Start relay 3. Front deicer relay 4. Blower relay 5. Wiper relay (Low) 6. ACC relay 7. IG1 relay 8. IG2 relay 9. Cooling fan relay 10. Wiper relay (High) 11. ...
