Hyundai Santa Fe: Line Pressure Control Solenoid Valve. Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: Line Pressure Control Solenoid Valve. Description and Operation

Hyundai Santa Fe DM 2013-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve. Description and Operation

Description

line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure.


26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...

See also:

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn signal is ...

If engine turns over normally but does not start
1. Check fuel level. 2. With the ignition switch in the LOCK position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose. 3. If the engine still does ...

Tire. Repair procedures
• Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident. Tire Wear 1. Measure the tread depth ...