Hyundai Santa Fe: Output Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: Output Speed Sensor. Repair procedures

Inspection

1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.

Removal

1.
Remove the valve body assembly.
2.
Disconnect the input & output speed sensor connector(A).
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Installation

1.
Install in the reverse order of removal.
•
Adding coolant.
•
Adding Automatic Transaxle Fluid(ATF).

Output Speed Sensor. Troubleshooting
Signal Waveform ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation
Description Torque converter control solenoid valve (T/CON) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...

See also:

Interior. Body Repair
Interior A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Interior B * These dimensions indicated in this figure are actual-measurement dimensions. ...

Rear Upper Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Seats
Front seat (1) Forward and backward (2) Seatback angle (3) Seat cushion height (Driver’s seat) (4) Lumbar support (Driver’s seat)* (5) Seat warmer* / Air ventilation seat* (6) Headrest Rear seat (7) ...