Hyundai Santa Fe: Rail Pressure Sensor (RPS). Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM can control correct injection amount and timing and adjusts
the fuel pressure with the fuel pressure regulator valve if the target pressure
and the actual pressure calculated by the RPS output signal are different.
Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 ...
Rail Pressure Sensor (RPS). Specifications
Specification ...
See also:
Forward and backward
To move the seat forward or backward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. ...
Front Wheel Repair procedures
Removal 1. Remove the driveshaft and axle. 2. Remove the propeller shaft (A). Tightening torque : 49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft) 3. Loosen the transfer upper & lower mounting bolts. (transfer ...
Front Bumper Cover. Components and Components Location
Component Location 1. Front bumper cover ...
