Hyundai Santa Fe (TM): Rear View Monitor (RVM)

Hyundai Santa Fe TM 2019-2023 Service Manual / Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM)

Description and operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the H/UNIT or the ECM (Reverse Display Room Mirror) mirror while backing-up.

This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Components and components location

Component Location

1. Rear view camera

2. H/UNIT

Schematic diagrams

Circuit Diagram

Repair procedures

Removal

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Remove the tailgate ganish (A).

3.	Remove the tailgate switch assembly.

4.	Remove the license lamp LH.

5.	Disconnector the connector (A) and then remove the rear view camera.

Installation

1.	Install the rear view camera.

2.	Install the and tailgate trim.

Cruise Control System (CC)

Description and operation Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, ...

Driver Parking Assistance System

Desctiprion and operation Description ADAS_PRK is a unit that controls the functions required for ADAS parking. If the ADAS_PRK is applied, the parking distance warning function is also controlled by the ...