Hyundai Santa Fe: Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures recommended for your vehicle.
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Repair procedures
Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the ...
Flex Steer. Repair procedures
Inspection 1. Check the audio remote control switch (A) for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel 2-7 180 Ω Set 2-7 330 Ω ...
