Hyundai Santa Fe (DM): 26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
|
| 3. |
Disconnect the solenoid valve connector(A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
|
26 Brake Control Solenoid Valve(26/B_VFS). Schematic Diagrams
Circuit Diagram ...
Line Pressure Control Solenoid Valve. Description and Operation
Description line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...
See also:
Steering Column and Shaft. Repair procedures
Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels can face straight ahead. 3. Remove the airbag ...
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
Rear parking assist system
The rear parking assist system assists the driver during backward movement of the vehicle by chiming if any object is sensed within a distance of 47 in. (120 cm) behind the vehicle. This system is a supplemental ...
