Hyundai Santa Fe (DM): All Wheel Drive (AWD) LOCK Indicator Light
This indicator light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When you select AWD Lock mode by pressing the AWD LOCK button.
- The AWD LOCK mode is to increase the drive power when driving on wet pavement, snow covered roads and/or off-road.
CAUTION - AWD Lock Mode
Do not use AWD LOCK mode on dry paved roads or highway, it can cause noise, vibration or damage of AWD related parts.
Front Fog Indicator Light
This indicator light illuminates: • When the front fog lights are on. ...
Cruise Indicator Light
This indicator light illuminates: • When the cruise control system is enabled. For more details, refer to “Cruise Control System” in section 5. ...
See also:
Heated Oxygen Sensor (HO2S). Specifications
Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.5 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) Output Voltage(V) RICH Approx. 0.9 LEAN Approx. 0.04 ...
Rear Pillar Trim. Components and Components Location
Component Location 1. Rear pillar trim ...
Rear Disc Brake. Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Loosen the hose eyebolt (B) and caliper mounting bolts (C), then remove the rear ...
