Hyundai Santa Fe (DM): Audio Unit. Repair procedures
Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center air vent duct (A).
|
3. |
Seperate the audio head unit (A) from crash pad after
loosening the screws (4EA).
|
4. |
Remove the audio head unit (A) after disconnecting
the connectors and cable.
|
Installation
1. |
Connect the audio unit connectors and cable.
|
2. |
Install the audio head unit.
|
3. |
Install the center air vent duct.
|
4. |
Connect the negative (-) battery terminal.
|
Audio Unit. Components and Components Location
Components Connector Pin Information No. Connector A Connector B 1 Rear left speaker (+) CAN High 2 Front left speaker (+) TMU Audio (+) (For USA) 3 Front right speaker (+) - 4 Rear right speaker (+) Steering ...Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected ...See also:
Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals ...
Components and Components Location
Components 1. Front pillar trim 2. Center pillar lower trim 3. Center pillar upper trim 4. Rear pillar trim 5. Cowl side trim 6. Front door scuff trim 7. Rear door scuff trim 8.Front door step trim 9. ...
Front Door Trim. Components and Components Location
Component Location 1. Front door trim ...