Hyundai Santa Fe (DM): Auto Head Lamp Leveling Unit. Description and Operation
Description
According to driving environment and loading state of vehicle,
head lamp lighting direction is changed to keep the driver's visibility range
and to protect the driver's vision from glare, aiming at safety driving.
Sensor integrated ECU mounting on the rear center arm drives
the actuator mounting on the head lamp since sensing the input signal following
the vehicle's statically changes.
Head lamp beam is automatically operated by chassis tilt.
Operation
Operating Procedure
1. |
Suspension angle change resulted from vehicle's load
change.
|
2. |
Sensor angle change.
|
3. |
Microprocessor calculates necessary head lamp angle
change amount.
|
4. |
Sending a proper signal to head lamp leveling device
and driving actuator.
|
Operating Condition
1. |
Ignition on
|
2. |
Low beam on
|
3. |
On stop : If sensor lever change is 0.3В° and above,
head lamp is operated after max. 1.5 sec.
|
4. |
On driving : If vehicle velocity is over 4km/h(2.48mile/h),
velocity change is not over 0.8-1.6km/h(0.5 ~ 1.0mile/h) per second,
and loading condition is changed, then head lamp is operated.
|
Components
1. |
Auto head lamp leveling unit
1. Leveling unit & sensor
2. Sensor mounting bracket
3. Sensor linkage
|
2. |
Actuator
|
Auto Head Lamp Leveling Unit. Schematic Diagrams
Circuit Diagram ...Auto Head Lamp Leveling Unit. Repair procedures
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned. 4. If the operation ...See also:
Multimedia Jack. Description and Operation
Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3, iPod and etc., through the vehicle's sound system when ...
Special Service Tools
Special Service Tools Tool (Number and Name) IIIustration Use 09546-26000 Strut spring compressor Compression of coil spring ...
Water pump. Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the drive belt after turning the drive belt tensioner ...