Hyundai Santa Fe (DM): Auto Head Lamp Leveling
Unit. Repair procedures
Inspection
| 1. |
Ignition "ON".
|
| 2. |
Turn on the head lamp switch.
|
| 3. |
Check for operation. If the aim of the head lamps
changes smoothly when the head lamp leveling switch is turned.
|
| 4. |
If the operation does not work well, inspect the
connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair
them as necessary, and recheck the system.
If the terminals look OK, go to step 5.
|
| 5. |
Substitute with a known-good head lamp assembly and
check for proper operation.
|
Removal
| 1. |
Remove the head lamp leveling unit connector (A).
|
| 2. |
Loosen the mounting bolts (2EA) of automatic head
lamp leveling unit (B).
|
| 3. |
Remove the head lamp leveling unit assembly.
|
Installation
| 1. |
Install the head lamp leveling unit.
|
| 2. |
Reconnect the head lamp leveling unit connector.
|
Auto Head Lamp Leveling
Unit. Description and Operation
Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from ...
See also:
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a PCM(ECM) ...
ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...
Power Door Lock Switch. Repair
procedures
Diagnosis With GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of power ...
