Hyundai Santa Fe (DM): AVN Head Unit. Repair procedures
Removal
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center air vent duct (A).
|
3. |
Remove the AVN head unit (A) after loosening the
mounting screws (4EA).
|
4. |
Remove the AVN head unit after disconnecting connectors
and cables (A).
|
Installation
1. |
Connect the AVN head unit connectors and cable.
|
2. |
Install the AVN head unit.
|
3. |
Install the center air vent duct.
|
4. |
Connet the negative (-) battery terminal.
|
AVN Head Unit. Components and Components Location
Components AVN (A/V & Navigation) Head Unit Connector Connector Pin Information No. Connector A Connector B Connector C 1 - MM CAN High - 2 Parking V VIDEO - (Dimming output) - 3 Parking V GND Parking ...Multimedia Jack. Schematic Diagrams
Circuit Diagram ...See also:
Turn signals when towing a trailer
When you tow a trailer, your vehicle has to have a different turn signal flasher and extra wiring. The green arrows on your instrument panel will flash whenever you signal a turn or lane change. Properly ...
Vehicle stability management (VSM)
This system provides further enhancements to vehicle stability and steering responses when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient of friction between right ...
Delivery Pipe. Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair ...